Aegis AEGIS 1000 Instrukcja Instalacji Pobierz pdf (Strona 42)

Page 42

MODEL AND SOFTWARE VERSION

The model number and software version for the system is displayed:

AEGIS 1000

S/W VERSION 2.0 ×

RESET SYSTEM EEPROM

Select the 1 (YES) key to reset the EEPROM. All programs, names, and setup items will be reset. All system RAM will also be

initialized and the system will restart. This option, in effect, allows the system to be restored to factory fresh configuration.

RESET SYSTEM EEPROM? 0

0=NO 1=YES ×

RESET SYSTEM RAM

Select the 1 (YES) key to cause all of the system RAM to be reinitialized. The time, date, and event log will be cleared. Other

volatile memory locations will also be reinitialized. The system RAM should only be reset if the system is acting strangely and

memory corruption is suspected. Resetting the system RAM will not reset any setup items stored in EEPROM.

RESET SYSTEM RAM? 0

0=NO 1=YES ↑

SETUP EXPANSION

To configure each expansion module that is installed on the Aegis 1000, from the Installer Setup menu, press the 7 (EXP) key.

MODULE 1 TYPE

The Module Type defines the function of each expansion module on the controller. Module 1 is the module with the ADDR

jumper set to 1. Set the module type from the list below. Press # to change the module type, then use the arrow keys to select the

proper module type, then press # to enter.

MODULE 1 TYPE 1

NOT USED #=CHNG ↓

Select from the following for the module with jumper set to 1:

MODULE TYPES NUMBER DESCRIPTION

NOT USED 0 No module is installed

HARDWIRE EXPNDR 1 Expansion Module installed

ALC 2 ALC Interface Module installed

AEGIS-LINK 3 Serial Interface installed using Aegis-Link protocol

PRO-LINK 4 Serial Interface installed using Pro-Link protocol

NOTES:

1. If the Expansion Module is used, if must be configured here.

2. If a Wireless Receiver is used and Expansion Module is also connected, all 16 zones (9-24) will be wireless zones. Outputs 1-

8 (Units 17-24) on the Expansion Module may be used; however the zones will be inactivated.

3. Only 1 Serial Interface Module can be installed and configured (Aegis-Link or Pro-Link). To configure the protocol for the

built-in serial port, set the "Serial 1 Function" to the desired protocol.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Brak uwag

Aegis AEGIS 1000 Instrukcja Instalacji Strona 42