Aegis AEGIS 1000 Instrukcja Instalacji Strona 32

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 31
Page 32
OUTPUT TYPE NUMBER DESCRIPTION
GENERAL PURPOSE 0 General Purpose Output
OK TO ARM 1 OK To Arm
ARMED 2 Armed
PRE-ALM SNDR 3 Pre-Alarm Sounder
INT SNDR 4 Interior Sounder
INT BURG SNDR 5 Interior Burglary Sounder
INT FIRE SNDR 6 Interior Fire Sounder
EXT SNDR 7 Exterior Sounder
EXT BURG SNDR 8 Exterior Burglary Sounder
EXT FIRE SNDR 9 Exterior Fire Sounder
BURG COMM 10 Burglary Communicator
FIRE COMM 11 Fire Communicator
AUX COMM 12 Auxiliary Communicator
SWITCHED POWER 13 Switched Power Output
For output types, the current setting is shown on the bottom line. Press ' # ' to select a new type from a list of output types. Use
the arrow keys to scroll through the list, or select the appropriate output type number. Then press ' # ' to enter the new type.
SELECT TYPE: 6
INT SNDR ×
SETUP ZONES
To setup the zone type for each security zone, from the Installer Setup menu, select the 2 (ZONE) key.
WIRELESS RECEIVER
A Wireless Receiver can be used to add 16 zones (9-24) to the Aegis 1000. If used, you must enable the following item:
WIRELESS RECEIVER: 0
0=NO 1=YES
NOTES:
1. If the Expansion Module is used, if must be configured under Setup | Installer | Expansion.
2. If a Wireless Receiver is used and the Expansion Module is also connected, all 16 zones (9-24) will be wireless zones.
Outputs 1-8 (Units 17-24) on the Expansion Module may be used; however the zones will be inactivated.
ZONE RESISTORS
This item is used to specify if the 1000-ohm end-of-line zone resistors will be used with zone inputs other than Supervised Fire
and Gas. If this item is set to "Yes", all zones will require an end-of-line resistor. The default setting is "Yes".
ZONE RESISTORS: 1
0=NO 1=YES ×
Z 1 TYPE THROUGH Z 25 TYPE
This item specifies the zone type for each zone.
ZONE 1 TYPE: 64
AUXILIARY #=CHNG ×
THROUGH
ZONE 25 TYPE: 64
AUXILIARY #=CHNG
Przeglądanie stron 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 49 50

Komentarze do niniejszej Instrukcji

Brak uwag